![]() ![]() Naive questions: - Is this all done now ? - Should I upload every file (tab) that was opened when I opened the OnStep or are they all dependent ones, so automatically everything got uploaded into the board ? The wiki 'Uploading Firmware' shows below the last step says >. It opened many tabs one of them was OnStep - Then I did Upload. Then I chose Onstep file from my folder in the IDE. ![]() Configure the board through board manager. Now flashing/uploading the Onstep into the board, few naive questions: - Connect the MKS L gen board into Arduino. Got the OnStep code unzipped into my windows folder, renamed the folder to OnStep. ![]() I (too) am trying this loading into an arduino board first time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |